
Technical Specifications
1177DE Network Dome Camera
Video Encoding MJPEG / H.264 (simultaneous dual stream)
Software
(FW-Manager
3.xx)
Supports 16, 25, 36, 64, 128, 256ch ( 9ch freeware available)
Full-featured PC NVR with matrix functionality
( Minimum PC requirement - XP, 2000 / Pentium IV 1.6GHz or above /
256MByte RAM or above / 64MByte video memory or above )
Video channels 1ch Video-output.
Accessory
[Protocol]
HTTP, RTP/RTSP, Multicast, 3GPP, TCP/IP, ARP, ICMP, Telnet, Ftp,
PPPoE, SMTP, DHCP, NTP, uPNP, and etc.
[SDK]
Open HTTP API / ActiveX for live-cast with audio & PTZ
System
Integration
Features
[Service]
Image upload service / notification service
Compression
H.264: 6 levels (low compression / highest / high / normal / low / lowest),
MJEPG: 1 level (highest)
Installation and
maintenance
Configuration: installation wizard, HTTP, telnet and console.
Upgrade firmware: HTTP, telnet & ftp (Firmware is available at
www.flexwatch.com)
Resolution
4CIF - 704x480 (NTSC) / 704x576 (PAL)
CIF - 352x240 (NTSC) / 352x288 (PAL)
QCIF – 176x112 (NTSC) / 176x144 (PAL)
Misc.
Transmit serial input data with video
Different time zones are supported
Date and time can be synchronized with an external NTP server
Live Casting
Up to 30/25 fps@ CIF (12.5KB) when simplex
System
hardware
32bit RISC CPU / Embedded Linux / 128MByte SDRAM / 8MByte Flash
AC 24V/1.0A, 32~122F(0~50C), 20~80% RH
Network
through-put
control
Frame rate control / Bandwidth control / CBR Approvals MIC,FCC, CE, RoHS, IP66
Audio
Encoding
8 bit PCM, Sampling rates 8KHz, Mono Audio Accessories
CD with installation wizard / User’s manual / Quick installation manual /
Transformer AC 24V(1.5A)[AC100~240V, 50/60Hz] / Power cord / LAN
cable / Mounting brackets / Connector kit
Audio channels
1ch Audio input / 1ch Audio
Full duplex live audio.
10/100 Base T Ethernet(auto-sensing)
1 opto-coupled inputs or 1 digital inputs (NC/NO selectable)
1 relay outputs
1 audio input / 1 audio output
Reset button for factory default
External
Interface
2 serial port (COM: RS-232, AUX: Built-in PTZ)
PTZ support
Max Speed: Pan 360
O
/sec, Tilt 200
O
/sec@preset mode
Rotation Angle: Pan 360
O
(endless), Tilt: 92
O
(auto flip)
Optical zoom x30, Digital zoom x10
250 Preset Positions, Swing, Group, 16 privacy zone.
Image sensor
1/4”Sony 410K Super HAD CCD
Resolution: 520 TV Lines
S/N ratio: 50dB or more(AGC OFF)
Electronic shutter speed:
1/60 ~ 1/100,000 sec (NTSC)
1/50 ~ 1/100,000 sec(PAL)
White Balance: ATW(indoor: 3,000K~6,500K / outdoor: 1,800K
~10,500K),AWC,MWB
UART support
Console, By-pass command to control UART device
X10 device command to control device over power line, Modem Support
( ISDN, PSTN and GSM )
Lens
IRIS control: Auto & Manual
F1.4-30, f=3.3mm wide to 99.0mm tele
Angle of view: 2.3 ~ 62.0 horizontal
Shutter speed: Auto or 1/120 ~ 1/60,000 sec
[ Trigger]
Video loss / Video recovered / Motion detection (144 area) /
1 alarm inputs / Boot finished / Serial input / Schedule / Trigger
combination is possible.
DIS (Digital Image Stabilizer)
DSS (Digital Slow Shutter)
SSNR (Noise Reduction at Low Light)
ICR (Day & Night)
AGC (Auto Gain Control)
Alarm Image
Management [ Alarm]
Image holding service (Max 15.5MByte pre-post alarm buffer)
Image upload service through E-mail / FTP (support pre & post)
Notification service through TCP / UDP / HTTP / 1 alarm outputs
Setting
BLC (Back Light Compensation)
Dynamic IP
support
Dynamic IP service using www.ipcctvdns.com
Color: 0.7 Lux (F1.6)
D&N: 0.1 Lux (F1.6)
Minimum
illumination
DSS(Digital Slow Shutter):0.0001 Lux(F1.6)
Security
Channel based user password protection for live-cast, PTZ, alarm output
and audio
Dimension 216.8 (D) x 289.2 (H)(in mm)
Software
(default
Web interface)
Live-cast, PTZ control, search through Web browser with audio
(Minimum PC requirement - XP, 2000, Vista / IE 6.x or later/Pentium lll
500MHz or above or equivalent AMD / 64MByte RAM or above /
CDROM)
Weight 5.5Kg(12.11 lbs)
FSC-20ECP
FSC-20ICB
FSC-20PMA
FSC-20ECP
FSC-30EWP
*Basically included
Kommentare zu diesen Handbüchern